Technical Specifications - Kärcher VC 3 Originalbetriebsanleitung

Cleaning the cyclone separator
Clean the cyclone separator in case of coarse soiling.
Illustration
 Push the lock and remove the dust container.
Illustration
 Turn the cover of the dust container in the counter-
clockwise direction so that the marking points to the
unlocking symbol.
 Remove dust container.
Illustration
For quick cleaning
 Clean the cyclone separator by using a soft sponge
and wipe with a moist cloth.
Illustration
For thorough cleaning:
 Disassemble the cyclone separator and clean the
sieve and ring under running water.
Note
The dust container can also be cleaned under running
water.
ATTENTION
– Do not immerse the cyclone separator into water.
– Do not wash the parts using detergents or boiling
water.
– Allow the cyclone separator and the dust container
to dry completely before installing it in the device.
Illustration
 Turn the cover of the dust container in the clock-
wise direction so that the marking points to the
locking symbol.
 Place the dust container into the device and snap it
into place.
Cleaning the motor protection filter
Wash the motor protection filter on a weekly basis or in
case of visible soiling.
The motor protection filter is located in the casing above
the dust container.
Illustration
 Push the lock and remove the dust container.
Illustration
 Unlatch the lock and open the cover.
 Remove the motor protection filter.
Illustration
 Remove the foam inlay from the frame.
 Wash foam inlay in warm water (max. 40°C).
 Thoroughly rinse the foam inlay and allow it to air-
dry.
ATTENTION
– Never clean the foam inlay in the washing machine
and do not dry it by means of a hair dryer.
– Do not wash the parts using detergents or boiling
water.
– Allow the foam inlay to dry completely before in-
stalling it in the device (at least 24 hours).
 Insert the motor protection filter with the foam inlay
into the top part of the dust container.
 Snap in the cover.
 Place the dust container into the device and snap it
into place.
Filter for pure blower air.
Note
 Clean the HEPA filter in case of visible soiling.
 Replace the HEPA filter in case of damage
10
HEPA filter
ATTENTION
Material damage due to incorrect cleaning of the HEPA
filter.
– Do not rinse out the HEPA filter!
– Never clean the filter in the washing machine and
do not dry it by means of a hair dryer.
Illustration
 Turn the cover in the counter-clockwise direction so
that the marking points to the unlocking symbol.
 Remove the HEPA-filter.
 Carefully empty/knock dirt out of the HEPA filter.
 Insert HEPA filter.
 Turn the cover in the clockwise direction so that the
marking points to the locking symbol.
Cleaning the accessories
Illustration
 Handle and suction tube can be disconnected in or-
der to clean or if clogged. Push the 2 interlocks and
pull apart.
 Connect handle and suction tube and insert.

Technical specifications

Kärcher
Voltage
Current type
Protective class
Weight (without accesso-
ries)
Action radius
Actual dust container vol-
ume
Dimensions
Length
Width
Height
Vacuum min.
HEPA filter
Eco design as per 666/2013:
Sound power level L
Rated power input
Subject to technical modifications!
– 7
EN
V 220-240 220-240
Hz 50/60
II
kg 4.4
m 7.5
l 0.9
mm 396
mm 270
mm 332
kPa ≥ 16
HEPA 13 HEPA 12
dB(A) 76
WA
W 700
50/60
II
4.4
7.5
0.9
396
270
332
≥ 16
76
700