Product Description And Specifications; Intended Use - Bosch 1 609 92A 4XS AS Originalbetriebsanleitung

or excess ive temperature. Exposure to fire or
temperature above 130°C may cause
explosion.
► Follow all charging instructions and do not
charge the battery pack or tool outside the
Bosch Power Tools 1 609 92A 4XS | (22.02.2019)
12 | English
Service
► Have your power tool serviced by a qualified
repair person
replacement parts. This will ensure that the
safety of the power tool is maintained.
Never service damaged battery packs. Service
►
of bat tery packs should only be performed by
the manufacturer or authorized service
providers.
Safety Warnings for Drills
Safety instructions for all operations
Hold the power tool by insulated gripping
►
surfaces, when performing an operation
where the cutting ac cessory or fasteners
may contact hidden wiring. Cut ting accessory
contacting a "live" wire may make exposed
metal parts of the power tool "live" and could
give the op erator an electric shock.
Safety instructions when using long drill bits
Never operate at higher speed than the
maximum speed rating of the drill bit. At higher
speeds, the bit is likely to bend if allowed to rotate
freely without contact ing the workpiece, resulting
in personal injury. Always start drilling at low
►
speed and with the bit tip in contact with the
workpiece. At higher speeds, the bit is likely to
bend if allowed to rotate freely without contact ing
the workpiece, resulting in personal injury.
pressure only in direct line with the bit and do
not apply excessive pressure.Bits can bend
causing breakage or loss of control, resulting in
personal injury.
Additional safety warnings
Switch the power tool off immediately if the
►
applica tion tool becomes blocked. Be
prepared for high torque reactions which
cause kickback. The applica tion tool
becomes blocked when it becomes jammed in
the workpiece or when the power tool
becomes over loaded.
Hold the power tool securely. When tightening
►
and loosening screws be prepared for
temporarily high torque reactions.
Secure the workpiece. A workpiece clamped
►
with clamping devices or in a vice is held more
secure than by hand.
using only identical
Apply
►
temperature range specified in the
instructions. Charging improperly or at
temperatures outside the specified range may
damage the battery and increase the risk of fire.
► Use suitable detectors to determine if there
are hid den supply lines or contact the local
utility company for assistance. Contact with
electric cables can cause fire and electric shock.
Damaging gas lines can lead to ex plosion.
Breaking water pipes causes property damage.
Always wait until the power tool has come
►
to a com plete stop before placing it down.
The application tool can jam and cause you to
In case of damage and improper use of the
►
battery, va pours may be emitted. The battery
can set alight or ex plode. Ensure the area is
well ventilated and seek medical attention
should you experience any adverse effects. The
vapours may irritate the respiratory system.
Do not open the battery. There is a risk of
►
short-circuit ing.
The battery can be damaged by pointed
►
objects such as nails or screwdrivers or by
►
force applied externally. An internal short
circuit may occur, causing the battery to burn,
smoke, explode or overheat.
► Only use the battery with products from the
manufac turer. This is the only way in which
you can protect the battery against dangerous
overload.
Protect the battery against heat, e.g.
against continuous intense sunlight,
fire, dirt, water and moisture. There is
a risk of explosion and short-circuiting.
Product Description and
Specifications
Read all the safety and general
instructions. Failure to observe the
safety and general in
structions may result in electric shock, fire
and/or serious injury.
Please observe the illustrations at the beginning of
this oper ating manual.

Intended use

The power tool is intended for driving and
loosening screws and for drilling in wood, metal
and plastic.
lose control of the power tool.