Faults/Protection - Ferroli EGEA 200 HT Handbuch Für Installation, Gebrauch Und Wartung

EGEA
200 HT - 260 HT

7.8 Faults/protection

This equipment has a self-diagnosis system that covers some possible faults or protections from anomalous operating conditions
through: detection, signaling and adoption of an emergency procedure until resolution of the fault.
Fault/Protection
Tank lower probe fault
Tank upper probe fault
Defrost probe fault
Inlet air probe fault
Evaporator inlet probe fault (not available for these models)
Evaporator outlet probe fault (not available for these models)
Compressor discharge probe fault (not available for these models)
Solar collector probe fault (not available for these models)
High pressure protection (not available for these models)
Recirculation circuit alarm
Temperature not suitable for heat pump operation alarm
(With alarm active the water is heated only with heating element)
No communication (with alarm active the equipment does not work)
Electronic fan fault (not available for these models)
In case of any of the above faults, it is necessary to contact the manufacturer's technical assistance service, indicating
the error code shown on the display or on the APP for smartphone.
cod. 3541T590 - Rev. 06 - 11/2022
Error code Display indication
P01
P02
P03
P04
P05
P06
P07
P08
E01
E02
PA
E08
E03
+ P01
+ P02
+ P03
+ P04
+ P05
+ P06
+ P07
+ P08
+ E01
+E02
+PA
+ E08
+ E03
109
EN