Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Maintenance and care
■
Cut the hedge regularly and only at the per-
mitted times.
■
Only cut off the thin branches and new
growth on the surface of the hedge; do not
cut too deep.
■
Always cut the two sides of a hedge first, fol-
lowed by the top. This prevents cut material
from falling into areas that you have not yet
trimmed.
■
Hedges should always be trimmed into a
trapezoidal shape (tapering toward the top).
This prevents the leaves on the lower
branches from being shaded out.
■
Make sure the motor is stopped before you
remove any cuttings.
■
When leaving/transporting the appliance:
■
Switch off the appliance.
■
Fit the protective cover.
■
Remove the battery.
■
After use, remove the battery and check the
appliance for damage.
7 MAINTENANCE AND CARE
WARNING! Danger of cuts and lacera-
tions. Danger of cuts and lacerations when
reaching into sharp-edged, moving appliance
parts and into cutting tools.
■
Before maintenance, care and cleaning work,
always switch off the appliance. Remove the
rechargeable battery.
■
Always wear protective gloves during mainte-
nance, care and cleaning work.
NOTE Repair work is only allowed to be car-
ried out by expert workshops or our service cen-
tres.
Malfunction
Engine does not start.
443164_a
Cause
Rechargeable battery is flat.
Rechargeable battery miss-
ing or rechargeable battery
not seated correctly.
Power supply is interrupted.
The motor protection switch
has switched off the motor
due to overload.
■
Do not expose the machine to rain or mois-
ture.
■
After each use, clean the housing and cutting
blades with a brush or cloth. Do not use wa-
ter and/or aggressive cleaning agents or sol-
vents - risk of corrosion and damage to the
plastic parts.
■
After every use, remove the rechargeable
battery and inspect the appliance for dam-
age.
■
Clean the cutting blade and spray with corro-
sion protection oil.
■
Regularly check the cutting blade. Contact
one of the manufacturer's service centres in
the event of:
■
Defective cutting blade
■
Blunt cutting blade
■
Excessive wear
■
Inspect all bolts for tightness.
■
Inspect the electrical contacts of the appli-
ance for corrosion, clean with a fine wire
brush if necessary and then spray with a con-
tact spray.
8 HELP IN CASE OF MALFUNCTION
CAUTION! Risk of injury. Sharp-edged
and moving appliance parts can lead to injury.
■
Always wear protective gloves during mainte-
nance, care and cleaning work!
NOTE For malfunctions that are not listed in
this table or that you cannot resolve yourself,
please contact our customer service.
Remedy
Charge the rechargeable battery.
Insert the rechargeable battery cor-
rectly.
1. Remove the battery.
2. Clean the plug contacts of the ap-
pliance.
Wait until the motor protection switch
enables the motor again.
25
Werbung
Inhaltsverzeichnis
