Maintenance And Care - AL-KO GS 3,7 Li Multi Cutter Betriebsanleitung

Information on operation
Storing the rechargeable grass and shrub
cutter and charger
Repairs
Danger - risk of injury!
Always put the blade protection into protection in
place and wear protective gloves!
3. Press both unlocking buttons together to take out
the blade. ( 3)
4. Lubricate the gearbox enclosure with grease
regularly.
5. Insert the blade into the mounting and press it
( 4)
6. Clean the blade with a brush or dry cloth. Remove
any impurities that may be present from the gear-
box enclosure. ( 5)
„ Only use if visibility is good.
„ Only work with a sharp cutter blade.
„ The operating time of the shrub cutter depends on
the condition of the battery and the properties of the
items being cut. Frequently switching the device on
and off reduces the operating time.
„ Store the device in a place inaccessible to children
and unauthorised persons.
„ Only store the device with the blade protection
attached.
„ Do not place any other objects on the device.
„ Store the device in a dry, frost-free location with an
ambient temperature between 0 °C and +35 °C.
„ Only store the device with the battery fully charged.
Recharge the battery for approximately 2 hours
after a 6-month storage period.
The optimum temperature for storing the device
is between 0 °C and 20 °C.
„ Repairs must only be carried out at AL-KO service
474 168_d
firmly into the base of the blade to click it into place.
centres or authorised specialist firms.

Maintenance and care

Transport
„ Only use original parts.
Danger - risk of injury!
Always wear work gloves when carrying out
maintenance on the cutter blade!
Danger - risk of injury!
Turn off the device when carrying out mainte-
nance work. The blades continue to move after
the motor has been switched off.
„ After cutting work, thoroughly clean the device with
a hand brush or a cloth.
„ Do not hose down the device with water! Water in-
gress can damage the switch as well as the battery
and the electric motor.
„ Regularly check the cutter blade for damage.
Replace stumps or damaged cutting blades before
using it for the next time.
„ Treat the cutting blade with oil or a lubricating spray
ute the oil better.
„ Professional inspection is necessary:
If the motor is blocked
If the cutting blade is bent or damaged
If the battery is damaged or drained
The battery has been tested according to the UN manual.
This is why the battery is not subject to the national and
international regulations concerning hazardous goods,
„ Only transport the battery in the device.
„ Regulations in relation to hazardous goods may ap-
ply when transporting several batteries.
„ Never carry the device by the cutting blade.
„ Only transport the device with the blade protection
attached.
after each use. Switch on the device briefly to distrib-
„
„
„
whether as individual item or when fitted to the device.
EN
15