Maintenance And Care; Storage; Help In Case Of Malfunction - AL-KO MULTITOOL MT 36 Li Betriebsanleitung

GB

7 MAINTENANCE AND CARE

WARNING!
Danger of cutting injuries
Danger of cutting injuries when reaching
into sharp-edged, moving appliance parts
and into cutting tools.
■
Before maintenance, care and clean-
ing work, always switch off the appli-
ance. Remove the rechargeable bat-
tery.
■
Always wear protective gloves during
maintenance, care and cleaning
work.
■
Do not get the machine wet or expose it to
moisture.
■
Clean plastic parts with a cloth and do not
use any cleaning agents or solvents.
■
Check the electrical contacts for corrosion,
clean with a fine wire brush if necessary and
then spray with a contact spray.
■
Check the cutting blade for damage and – if
damaged – have replaced.
■
Clean the cutting blade and spray with rust-
proofing oil.

8 STORAGE

Thoroughly clean the appliance after each use
and – if present – attach all covers. Store the ap-
pliance in a dry, lockable place out of the reach of
children.
Carry out the following jobs before intervals in
work lasting for longer than 30 days:
■
Clean the cutting blade and spray with rust-
proofing oil.
■
Thoroughly clean the appliance and store it in
a dry place.

9 HELP IN CASE OF MALFUNCTION

CAUTION!
Risk of injury
Sharp-edged and moving appliance parts
can lead to injury.
■
Always wear protective gloves during
maintenance, care and cleaning
work.
20
Malfunction Cause
Cutting No oil on the
blade be- cutting
comes hot blade.
when run-
ning. Gener-
ation of
smoke.
■
Cutting
blade is
blunt.
■
Nicks in
the cut-
ting
blade.
Branches Cutting
are not blade is
cleanly cut. blunt.
Branches
The sliding
are often
play of the
jammed in
cutting blade
the cutting
is too great.
blade.
Motor run- Appliance
ning, but the faults
cutting blade
does not
move.
Appliance vi- Appliance
brates un- faults
usually.
Other faults See "Multitool MT 36 Li – basic
appliance" operating instruc-
tions.
NOTE
For malfunctions that are not listed in this
table or that you cannot resolve yourself,
please contact our customer service.
Maintenance and care
Remedy
1. Switch off the
appliance
and remove
the re-
chargeable
battery.
2. Clean and oil
the cutting
blade.
3. Insert the re-
chargeable
battery
again.
Contact an AL-
KO service
centre.
Contact an AL-
KO service
centre.
Contact an AL-
KO service
centre.
Contact an AL-
KO service
centre.
Contact an AL-
KO service
centre.
HTA 36 Li