Creating Custom Programs; Previewing Custom Programs - Sygonix 2525293 Bedienungsanleitung

You can create, preview, and update custom programs. For each weekday, you can program three (3x) periods.

10.7.1 Creating custom programs

To create a custom program, you will loop through each weekday and set the start and end times of each program-
mable period. You can only create one custom program.
The below diagram shows the programming flow to create a custom program.
d1
d2...d7
Each weekday (d1 = Monday, d2 =Tuesday, ..., d7 = Sunday) is divided into three programmable periods (1., 2., 3.)
during which the comfort or anti-frost working mode will be running. Each programmable period has a start (S) and
end time (E).
To create a custom program, follow the below steps:
Notes:
If you want to operate the heater in anti-frost working mode for a programmable period or for the full weekday,
touch the timer button TIMER to skip to the next period or weekday.
Examples:
– If the display shows 1. touch the timer button TIMER to skip to the following programmable period 2.
– If the display shows d1, touch the timer button TIMER to skip to the following weekday d2.
1. Repeatedly touch the mode selection button MODE until UP shows on the display.
2. Touch the program button PROG to enter the programming mode.
à
d1 flashes on the display.
3. Touch the menu button UP to enter the first programmable period.
à The display shows 1. and the symbol HOT flashes on the display.
4. Use the menu buttons UP and DOWN to set the start time. Touch the button TIMER to save the time setting.
5. Use the menu buttons UP and DOWN to set the end time. Touch the button TIMER to save the time setting.
à
The display shows 2. and the symbol HOT flashes on the display.
6. Continue programming the second (2.) and third (3.) period in the same way.
7. Continue programming the other weekdays (d2 ... d7).
à
After all weekdays are programmed, the symbol HOT continues to flash for 2 minutes.
8. Set temperature and heating power. For details, see

10.7.2 Previewing custom programs

After programming a custom program, you can preview or review the program settings.
1. Touch and hold the program button PROG for 3 seconds to enter the preview mode.
34
1.
S E
2.
S E
Setting room temperature
3.
S E
[} 32].