Display; Installation; Operation - Sygonix 2525293 Bedienungsanleitung

8.2 Display

Heater operates at full power
(2000 W).
HOT
The anti-frost working mode is
activated.
FROST
A timer is set
TIMER
Pre-set mode
P1 ... P5

9 Installation

Before operation, the heater must be mounted to a wall in a vertical position. The installation location must comply
with the locally applicable regulations.
Important:
If you are in any doubt, do not carry out the installation yourself; ask a qualified person to do it for you.
Important:
In order to avoid a hazard for very young children, install the heater and towel rack so that the lowest heated rail
of the towel rack is at least 600 mm above the floor.
1. Refer to the installation diagrams at the front of these operating instructions.
2. Check that the installation location for the heater meets the requirements shown in figure [1].
3. Follow the figures [2] to [7] to install the heater and towel rack. Figure [8] shows the installed heater with towel
rack.

10 Operation

You can operate the heater in different modes that suit your needs.
Manual mode:
With the manual mode, you are in charge of setting room temperature and heating power. In manual mode you can
also set countdown timers.
Pre-set programs:
Pre-set modes allow you to conveniently select between different temperature settings and operation times. Every
pre-set mode relies on two working modes: comfort and anti-frost.
Custom program mode:
Custom programs divide every weekday into distinct programmable time periods of user-defined duration. For each
period, you can set to operate the heater in comfort (default: 24 °C) or anti-frost (5 °C) working mode. Once you
have programmed a custom program it is stored in memory and you can activate the program at any time.
30
Heater operates at medium power (1000 W).
MED HOT
The open window sensing mode is activated
An open window was detected
WINDOW
d1 ... d7 Monday, Tuesday, ..., Sunday
The programming mode is activated.
UP