Full Day Anti-Frost Mode; Custom Program Mode; Creating Custom Programs - Sygonix 2525295 Bedienungsanleitung

Preconditions:
a
The heater operates in manual mode.
1. Touch the timer button TIMER to activate the timer mode.
à
The symbol TIMER and the countdown time flash on the display.
2. Use the menu buttons UP and DOWN to set the desired operating hours.
à
The setting will be saved automatically after 5 seconds from the last input and the timer starts counting down.
à
The symbol TIMER shows on the display until the countdown time has elapsed.
à
The heater switches off after the countdown time has elapsed.
Cancelling timers
You can cancel an active timer at any time.
1. Touch the timer button TIMER to cancel the timer mode.

11.6 Full day anti-frost mode

The anti-frost mode maintains the room temperature at 5 °C to prevent frost.
Preconditions:
a
The heater is operating.
1. Repeatedly touch the mode selection button MODE until the symbol FROST shows on the display.
à
The heater operates in anti-frost mode until you change the mode or switch the heater off.

11.7 Custom program mode

Custom programs divide every weekday into distinct programmable time periods of user-defined duration. For each
period, you can set to operate the heater in comfort (default: 24 °C) or anti-frost (5 °C) working mode. Once you
have programmed a custom program it is stored in memory and you can activate the program at any time.
You can create, preview, and update custom programs. For each weekday, you can program two (2x) periods.

11.7.1 Creating custom programs

To create a custom program, you will loop through each weekday and set the start and end times of each program-
mable period. You can only create one custom program.
Note:
For times outside your programmed time periods, the heater will operate in anti-frost working mode.
Preconditions:
a
The heater is operating.
1. Repeatedly touch the mode selection button MODE until PROG shows on the display.
2. Touch the program button PROG to enter the programming mode.
3. Touch the menu button UP to enter the first programmable period.
à
The display shows 1: and the symbol HOT flashes on the display.
4. Use the menu buttons UP and DOWN to set the hours of the start time. Save with the button TIMER. Set the
minutes of the start time and save again.
5. Use the menu buttons UP and DOWN to set the hours of the end time. Save with the button TIMER. Set the
minutes of the end time and save again.
34