10.1 Managing the power supply
The heater is equipped with a main switch to connect and disconnect the power supply.
Connecting the power supply
1. Connect the mains cable to the mains supply.
2. Flip the main switch to the position I.
à
An audible sound is emitted.
à
After 3 seconds, the heater enters the standby mode.
à
The heater is ready for use.
Disconnecting the power supply
1. Flip the main switch to the position 0.
2. Disconnect the mains cable from the mains supply.
10.2 Switching the heater on and off
After the heater is connected to the mains supply you can switch the heater on and off via the touch panel.
Preconditions:
a
Main switch is in the position I.
1. Touch the power button ON/OFF to switch the heater on.
à
The heater starts heating.
à
The display shows the set temperature.
2. Touch the power button ON/OFF to switch the heater off.
à
The fan continues to run for 30 seconds to cool the internals.
10.3 Setting weekday and time
By setting the weekday and time, you will align the heater clock to the weekday and time settings of your location.
This is important so that you can make use of the pre-set modes and custom programs.
Example: To set the internal clock to "Wednesday, 12:45", you will enter d3 (Wednesday), 12 (h), 45 (min).
Preconditions:
a
The heater is operating.
1. Touch and hold the timer button TIMER for 3 seconds to enter the day and time setting mode.
à
d1 will flash on the display.
2. Use the menu buttons UP and DOWN to select the current weekday: d1 = Monday, d2 = Tuesday, ..., d7 =
Sunday.
3. Touch the timer button TIMER to save the setting.
à
The hours flash on the display.
4. Use the menu buttons UP and DOWN to select the hours of the current time.
5. Touch the timer button TIMER to save the setting.
à
The minutes flash on the display.
6. Use the menu buttons UP and DOWN to select the minutes of the current time.
31