Balluff BVS ID-M1280 F1-L3 Serie Kurzanleitung Seite 3

BVS ID-M1280_F1-L3- _ _ _
Identsensor
Condensed Guide
The CE Mark verifies that our products
meet the requirements of the current
EU Directive.
Validity
This Condensed Guide applies to the following variants of
the Identsensor:
Order code Type
BVS0060 BVS ID-M1280BF1-
L3-000
BVS0061 BVS ID-M1280CF1-
L3-000
These Condensed Guide instructions apply only to the
setup of the Identsensor. You have access to the detailed
instructions for the Identsensor on www.balluff.com
Safe operation requires that the operating inst-
ructions for the Identsensor and the warning and
safety instructions it contains must be read and
observed.
Connections
1
2
Connection Function
Power / I/O Operating supply and IO-Link connection of
Identsensor
IIoT Integrates the Identsensor in a local network.
I/O Light 2 I/O signals and operating voltage output, e.g.
for an external lighting
Pin assignment
Power / I/O
4-pin M12 plug, A-coded
Pin Signal
1 PWR_IN
2 I/O
3 GND
4 I/O
1 english
Description
1D/2D code sensor, auto-
focus, w/r light, IO-Link
1D/2D code sensor, auto-
focus, w/IR light, IO-Link
1 Power / IO
2 LAN
3 I/O Light
3
Function
Operating voltage
Trigger
Ground
IO-Link protocol / SIO
Pin assignment (continued)
The digital sensor inputs correspond to the guide-
line concerning inputs, EN 61131-2,Type 3. The
maximum load on any output is 50 mA. The total
current of the module must not exceed 4 A per pin.
The load or supply must be limited accordingly.
LAN (Gigabit Ethernet)
8-pin M12 socket, X-coded
Pin Signal
1 BI_DA +
2 BI_DA –
3 BI_DB +
4 BI_DB –
5 BI_DD +
6 BI_DD –
7 BI_DC –
8 BI_DC +
I/O Light
5-pin M12 socket, A-coded
Pin Signal
1 PWR_IN
2 I/O
3 GND
4 I/O
5 Not used
Startup
CAUTION
Do not stare into emitted light!
Risk of glare and irritation!
► The device must be mounted in such a way that,
even during operating no staring into the light source
is possible.
NOTICE
Hot surface!
Danger of burns.
► Prior to touch, please be sure that the housing is not
too hot.
Function
Bidirectional data, Pair A +
Bidirectional data, Pair A –
Bidirectional data, Pair B +
Bidirectional data, Pair B –
Bidirectional data, Pair D +
Bidirectional data, Pair D –
Bidirectional data, Pair C –
Bidirectional data, Pair C +
Function
Operating voltage
Not used
Ground
External light output
None. Pin may not be
used.