Wired Connection - ieGeek IE20 Bedienungsanleitung

2. your router opens DHCP. You can log in router setting, find the DHCP and check
if it's closed. If DHCP is closed, router will not distribute IP address to your
camera, and the camera will also fail to connect to the Internet.
3. the network you used is 2.4GHz rather than 5.0GHz.
4. Wi-Fi SSID and Wi-Fi password don't include special character, such as:
!@#$%^&*()_+
5. there is no limit to the number of devices to connect the router.
6. camera's antenna is tight if you choose Wi-Fi connection.
Notice:
1. If you choose Wi-Fi connection, please make sure the Wi-Fi signal connected to
the camera is over 80%.
2. If your camera can't connect well but your network is good, please take out your
micro SD card and try to reconnect it. Maybe the micro SD card is incompatible.
3. If there are excessive devices connect to your Wi-Fi, it will cause the IP address
conflict so that it will fail to connect to Wi-Fi.

Wired Connection

1. Connect the camera into the router via an Ethernet cable and then plug the
power supply adapter in.
2. Open CamHipro and click 'Add Device' - 'IP camera' - 'New device'
-'Connected network cable' - choose the camera UID you want to connect -
enter initial password 'admin' - 'Add to'.
4