Herunterladen Inhalt Inhalt Diese Seite drucken

ieGeek IE20 Bedienungsanleitung Seite 20

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 24
⑥ Please make sure that there is no limit to the number of devices to connect
the router.
⑦ Please make sure the Wi-Fi signal is over 80%. You can test it in "Wi-Fi setting"
on app when you connect the camera with internet cable.
⑧ Please press the "reset button" more than 20 seconds under charging to reset
the camera if you want to change connection.
Notice:
1. If you choose Wi-Fi connection, please make sure the Wi-Fi signal connected to the
camera is up to 80%.
2. If your camera can't connect well but your network is good, please take out
your SD card and try again, may the SD card is incompatible. If the devices
connected to Wi-Fi are excessive, it will cause the IP address conflict and fail
to connect to Wi-Fi.
3. If you input the Wi-Fi password wrong it locks you out of the functions. So you
can 'Edit' the camera and delete it, then re-set up the camera.
Q3: The camera is offline after a few months? It cannot be connected
automatically after being offline?
A3:
Please check:
① If the camera is powered normally or not.
② If the antenna is tightened.
③ If the connected devices are excessive or not.
④ If the signal intensity changes or not.
⑤ If there is IP address conflict or not.
Please reboot your camera and the router to check it again. Just unplug the
power supply and plug it back.
If it can't connect, please take out the micro SD card and reset the camera,
then reconnect it.
If all methods can't do anything, please contact us via
service@iegeek.com.
Q4: How to reconnect a disconnected camera which is installed on wall?
A4:
After the camera has been installed on the wall, it is not necessary to
remove the camera. You can use AP mode to connect your camera.
Here are the steps:
① Delete the camera from your app first, then re-start your router.
② Press reset button for 20 seconds, you can see three cables on your camera, the
first one is for RJ45 port, the second one is for power supply, the third one is
reset button.
③ Wait for 1-2 minutes, the camera need to reboot at this time, you don't need to do
any things, just wait for it.
④ Access your phone's WLAN Setting, and find the Wi-Fi which named IPCAM-
XXXXX(such as this).
16

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis