Sharpening Wedge; Disposal; Troubleshooting - Zipper Maschinen ZI-HS8TN Betriebsanleitung

17.5 Sharpening Wedge

This log splitter is equipped with reinforced splitting wedge which blade is specially treated. After long
periods of operation, and when required, sharpen the wedge using a fine toothed file removing any burrs or
flat spots on the edge.

18 DISPOSAL

Observe the national waste disposal regulations. Never dispose of the machine, machine
components or equipment in residual waste. If necessary, contact your local authorities for
information on the disposal options available.
If you buy a new machine or an equivalent device from your specialist dealer, he is obliged
in certain countries to dispose of your old machine properly.

19 TROUBLESHOOTING

Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or death.
 Always disconnect the machine from the power supply before maintenance or
repair work and secure it against unintentional reconnection.
Many possible sources of error can be excluded in advance if the machine is properly connected to the
mains. If you are unable to carry out necessary repairs properly and/or do not have the required training,
always consult a specialist to solve the problem.
PROBLEM
Motor does not start
Incorrect motor rotation
direction
Log Splitter does not work
while motor running
Log Splitter works with
abnormal vibration and
noise
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
Change the hydraulic oil:
• Remove the oil drain plug to drain the oil from the hydraulic
system.
• Use a drip pan to collect waste oil and particles.
• Inspect the oil for metal chips. (Metal chips in the oil are an
indication of increased wear.)
• After the oil has been completely drained from the machine,
reinstall the drain plug.
• Top up the recommended fresh hydraulic oil via the oil filler
plug.
• After changing the oil, actuate the wood splitter several times
without actually splitting any wood.
•
Use a dipstick to check the oil level.
WARNING
PROBABLE CAUSE
Switch is Off
•
Incorrect connection
•
Valve is not opened owing to
•
the connection parts loosening
Control Levers or connection
•
parts bent
Lower hydraulic oil level
•
• Lower hydraulic oil level
REMEDY SUGGESTED
Set switch to On
•
Use the phase inverter to
•
change the polarity of one of
the phases on the motor.
Check and tighten the parts
•
Repair the bent parts
•
Check and refill hydraulic oil
•
• Check and refill hydraulic oil
DISPOSAL
28
ZI-HS8TN