Sharpening The Wedge; Disposal; Troubleshooting - Zipper Maschinen ZI-HS5TN Betriebsanleitung

22.3

Sharpening the wedge

The wood splitter is equipped with a re-inforced splitting wedge with a specially treated cutting
edge. After a long period of operation and if necessary, sharpen the wedge with a fine file to
remove burrs or notches.
23

DISPOSAL

Observe the national waste disposal regulations. Do not dispose of the machine,
machine components or equipment in residual waste. If necessary, contact your
local authorities for information on the disposal options available. If you buy a
new machine or an equivalent device from your specialist dealer, he is obliged in
certain countries to dispose of your old machine properly.
Waste oils are toxic and must not be discharged into the environment. If
necessary, contact your local authorities for information on proper disposal.
24

TROUBLESHOOTING

PROBLEM
Failure to split logs
The log pusher moves jerkily,
taking unfamiliar noise or
vibrating a lot
Oil leaks around cylinder ram or
from other points
ZIPPER MASCHINEN GmbH
ZI-HS5TN; ZI-HS7TU
PROBABLE CAUSE
Log is improperly positioned
The sizes or hardness of the log
exceeds the capacity of the
machine
Wedge cutting edge is blunt
Oil leaks
Unauthorized adjustment was
made on max. pressure limiting
screw. Lower max. pressure
rating was set.
Lack of hydraulic oil and
excessive air in the hydraulic
system.
Air sealed in hydraulic system
while operating
Bleed screw is not tightened
before moving the log splitter.
Oil drain bolt with dipstick is not
tight.
Hydraulic control valve assembly
and / or seal(s) worn
All repair work on this machine must be carried out
by a specialist for this product!
www.Zipper-Maschinen.at
DISPOSAL
REMEDY SUGGESTED
Refer to "Log Splitter Operation"
section for correct log loading.
Reduce the log sizes before
splitting it on the log splitter.
Refer to "Sharpening Wedge"
section to sharpen the cutting
edge.
Locate leak(s) and contact the
dealer
Contact your distributor.
Check oil level for possible oil
refilling.
Contact your distributor.
Loosen bleed screw by 3–4
rotations before operating the log
splitter.
Tighten the bleed screw up
before moving the log splitter.
Tighten the oil drain bolt with
dipstick.
Contact your distributor.
41