Assembly - Zipper Maschinen ZI-HS8TN Betriebsanleitung

15

ASSEMBLY

ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
1. Assemble the wheels
Pass the axle through the wheel from the
outside and put two washers on it as shown
in the picture. Slide the axle into the two holes
at the base of the log splitter and secure it
with another washer and an R-pin from the
inside. Put on the wheel cap.
2. Assemble working table
- Before mounting, loosen the star knob by
turning it anticlockwise.
-
Unfold the log support table and make sure
that the three parts are on the same surface
level.
- Insert the hooks of the log support table into
the brackets.
- Tighten the star knob
ASSEMBLY
23
ZI-HS8TN