Herunterladen Inhalt Inhalt Diese Seite drucken

Sharpening Wedge; Disposal - Zipper Maschinen ZI-HS8TN Betriebsanleitung

Vorschau ausblenden Andere Handbücher für ZI-HS8TN:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

17.3

Sharpening Wedge

This log splitter is equipped with reinforced splitting wedge which blade is specially treated.
After long periods of operation, and when required, sharpen the wedge using a fine toothed file
removing any burrs or flat spots on the edge.
18

DISPOSAL

Observe the national waste disposal regulations. Do not dispose of the machine,
machine components or equipment in residual waste. If necessary, contact your
local authorities for information on the disposal options available. If you buy a
new machine or an equivalent device from your specialist dealer, he is obliged in
certain countries to dispose of your old machine properly.
Used oils are toxic and must not be disposed into the environment. If necessary,
contact your local authorities for information on proper disposal.
19
TROUBLESHOOTING
Danger due to electrical voltage! Manipulating the machine with the power supply
up may result in serious injury or death. Before carrying out any troubleshooting
work, always disconnect the machine from the power supply and secure it against
unintentional recommissioning.
Many possible sources of error can be excluded in advance if the machine is properly connected
to the mains. If you are unable to carry out necessary repairs properly and/or do not have the
required training, always consult a specialist to solve the problem.
PROBLEM
Motor does not start
Incorrect motor rotation
direction
Log Splitter does not work
while motor running
Log Splitter works with
abnormal vibration and noise
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
W A R N I N G
PROBABLE CAUSE
Switch is O
FF
Incorrect connection
Valve is not opened owing to
the connection parts loosening
Control Levers or connection
parts bent
Lower hydraulic oil level
Lower hydraulic oil level
DISPOSAL
REMEDY SUGGESTED
Set switch to O
N
Use the phase inverter to
change the polarity of one of
the phases on the motor.
Check and tighten the parts
Repair the bent parts
Check and refill hydraulic oil
Check and refill hydraulic oil
27
ZI-HS8TN

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis