Assembly - Zipper Maschinen ZI-HS8TN Betriebsanleitung

15

ASSEMBLY

ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
1. Assemble the wheels
Pass the axle through the wheel from the
outside and put two washers on it as shown
in the picture. Slide the axle into the two
holes at the base of the log splitter and
secure it with another washer and an R-pin
from the inside. Put on the wheel cap.
2. Assemble working table
- Before mounting, loosen the star knob by
turning it anticlockwise.
- Unfold the log support table and make sure
that the three parts are on the same
surface level.
- Insert the hooks of the log support table
into the brackets.
- Tighten the star knob
ASSEMBLY
22
ZI-HS8TN