Operating Conditions; Tools; Working Instructions; Service & Maintenance - SUHNER LSB 20 Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für LSB 20:

Inhaltsverzeichnis

Verfügbare Sprachen

2.4 Operating conditions

Temperature range during operation: 0 to +40°C

Relative air humidity: 95% at +10°C not condensed

3. handling / Operation

Use only clean tools!

3.1.1 Changing/Fitting the tool

Hold spindle by wrench flats with open end wrench and

release/tighten down collet chuck with open end wrench.

Perform a trial run a minimum over a period of 30 seconds

without load.

On failure of the compressed air release the valve

lever! To achieve an optimum result, move grin-

ding tool uniformly back and forth with light pres-

sure. Excessive pressure lessens the working capability

of the machine, as well as the life of the grinding tool.

4. Service / Maintenance

Without a tool clamped in check no-load

speed periodically and after each mainte-

nance. Even if the machine still operates

perfectly, the motor should be removed, cleaned and the

four slides checked for wear by a specialist after approx.

300 to 400 operating hours.

Inhaltsverzeichnis