Eneral Notes On Safety; Intended; Incorrect Use; Ec Ce - SUHNER LSA 79 Originalbetriebsanleitung

1. n
1.1 General notes on safety
This operation manual is applicable for the machine LSA
79.
The machine may only be handled by personnel
who are qualified.
1.2 Use of the machine for purposes for
which it is intended
The machines are intended for the purpose of cutting,
roughing and brushing of metal and stone materials.

1.3 Incorrect use

All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 EC declaration of conformity
Translations of the «EG-Koformitätserklärung (Original)».
Otto Suhner GmbH of Trottäcker 50, D-79713 Bad Säck-
ingen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side)
complies with the requirements under the Directive
2006/42/EG. Applied standards: EN ISO 12100, EN ISO
11148. Document Agent: M. Voyame. D-Bad Säckingen,
07/2019. M. Voyame/Managing Division manager
2. c
2.1 Prior to taking the machine into service
Use oiled compressed air (see also air quality un-
der section 2.3). Observe national regulations.
2.1.1 Fitting of hose coupling
Fitting of hose coupling inside diameter min. 4.5mm
(available as optional accessory, item no. 90805100).
16
s
otes on aFety
ommIssIonIng

2.2 Taking the machine into service

Before connecting the tool to the com-
pressed air supply set the rotary valve to
the «OFF» position! The tool may be swit-
ched on only when the lock and attachment have been
installed correctly.
2.2.1 Turn on/Turn off
Switch on the tool by turning in the direction of the arrow
to the stop. Turn back to switch off the tool.
Before cutting off the compressed air supply, al-
ways set the machine to the «OFF» position so
that the tool cannot be reactivated inadvertently.
2.3 Rating data
Pressure
Power output
Air consumption full load
Air consumption at idling
Setting oiler idle
No-load speed
Max. wheel diameter
Max. chuck diameter
Sound pressure level EN ISO 15744 71.9dB(A), K=3dB(A)
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight with hose

2.4 Operating conditions

Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3.
handlIng

3.1 Tools

Use only clean tools!
max. 6.3bar
110W
0.29m /min
3
0.31m /min
3
about 1-2 drops/min
77000min
-1
10mm
3mm / 1/8"
1.54m/s , K=0.65m/s
2 2
2/4/4
0.310kg
/ o
PeratIon