Cleaning And Maintenance; Emptying And Rinsing The Water Tank; Removing Limescale - Siguro SGR-ST-D400W Bedienungsanleitung/Übersetzung Der Originalanleitung

a short time and wipe dry immediately.
Do not use the steam cleaner to clean parquet, or unsealed wood.
Warning:
Do not use the steam cleaner to clean electric or electronic devices.

CLEANING AND MAINTENANCE

Before cleaning or any maintenance, always switch off the appliance, disconnect the
plug from the power outlet and allow it to cool down completely. Clean the appliance
after each use to prolong its life.
Warning:
Never immerse the appliance, the power cable and plug in water or any
other liquid.
Do not use plastic or metal scrapers, harsh cleaners, chemicals, petrol, solvents or
other similar substances to clean any parts of the appliance. The surface finish could
be seriously damaged.

Emptying and rinsing the water tank

1. To prevent scalding from escaping steam or hot water while releasing the cap,
place a dry cloth over it.
2. Carefully release the safety cap and unscrew it anti-clockwise.
Warning:
Never release the safety cap by force. If it is not possible to release by regu-
lar, adequate power, wait till the temperature and pressure decrease. Do
not touch the metal parts of the cap. These are very hot, and they may
cause scalding when misused.
3. Pour out the rest of the water from the tank.
4. Insert the funnel in the tank neck and pour clean inside.
5. Screw the safety cap clockwise and tighten firmly.
6. Shake the steam cleaner intensively to release the mineral deposits at the bottom
of the tank.
7. Release the cap and pour out water.
8. Allow to dry.

Removing limescale

Regular use of tap water can cause the mineral deposits in water to settle and limesca-
le to form. It must be removed depending on the water hardness and frequency of
use.
Note:
If you use distilled water, there is no need to remove limescale.
The table below shows the recommended intervals of removing limescale
– see the column "Number of fillings".
EN - 11
EN