Filling The Water Tank; Using The Steam Cleaner - Siguro SGR-ST-D400W Bedienungsanleitung/Übersetzung Der Originalanleitung

e.g., from curtains or furniture, etc.
The cloth is washable so that you can re-use it. Pay attention when removing the cloth
from the nozzle after use as the cloth may be very hot.
Window wiper
Attach the window wiper to brush nozzle so that the protrusions at the bottom of the
wiper fit to the openings at the bottom of the nozzle. And then attach the upper part
of the wiper to the nozzle until it clicks.
The window wiper is used to wipe steam and water from windows, glass door, or wall
tiles.
Warning:
Always make sure the steam cleaner is switched off and unplugged when
you attach or remove the accessory. Before removing the accessory, wait
at least 5 minutes to cool down. The accessory becomes hot during use.
There is a risk of injury or scalding from hot steam or water. Never remove
the accessory when the steam cleaner is used.

Filling the water tank

1. Place the steam cleaner on a flat, dry, and stable surface.
2. Unscrew the safety cap anti-clockwise.
3. Insert the funnel in the tank neck and pour clean and cold water inside. The
maximum possible volume of the water tank is 250 ml. Use the supplied
measuring cup to fill the water tank.
4. Screw the safety cap clockwise and tighten firmly.
Note:
It is recommended to use distilled water, especially if you have very hard
water. That will prevent the formation of limescale. Always pour only the
maximum volume into the water tank. More water in the tank will cause
hot water to drip from the nozzle. If there is little water in the tank, not
enough pressure will be created, and therefore little steam. You can shor-
ten the heating time by pouring warm water.
Warning:
Never use the steam cleaner with an empty water tank. Use only clean
water.

Using the steam cleaner

1. Attach the desired accessory to the steam cleaner and check the tank is fill with
water.
2. Place the steam cleaner on a flat, dry, and stable surface and insert the plug to a
grounded power socket.
3. Press the main switch, the steam cleaner will turn on and LED will light up red
which means the steam cleaner is heating. The heating time is usually 4 minutes,
depending on the temperature and volume of water in the tank.
4. Once the LED lights up green, the steam cleaner is ready to use.
5. Press the safety lock and slide the button to OPEN position to unlock the steam
button.
6. Take the handle and press the steam button. The steam cleaner will start to
produce steam.
7. The steam cleaner will produce steam as soon as you keep the steam button
EN - 9
EN