Filling Water - Siguro SGR-ST-D400W Bedienungsanleitung/Übersetzung Der Originalanleitung

EN
pressed. Once it is released, the steam will stop.
8. If LED lights up red during use, the safety thermal fuse has been activated, which
protects the steam cleaner from damage. This is a normal phenomenon, and you
can normally use the steam cleaner.
Warning:
Be careful while using not to get scalded from the hot steam.
9. After use, release the steam button and slide the button to LOCK position. The
safety lock pops up and the steam button will be locked. Press the main switch
to turn the steam cleaner off. Before other manipulation (filling water, changing
accessory), allow it to cool down for at least 5 minutes. Before cleaning, allow it to
cool down completely.

Filling water

If you notice decrease in pressure and steam amount while using, it is necessary to
add water to the tank.
Warning:
Never use the steam cleaner with an empty water tank. There is a risk of
total damage.
1. Release the steam button and slide the button to LOCK position. The safety lock
pops up and the steam button will be locked. Place the steam cleaner on a flat, dry,
and stable surface.
2. Press the main switch to turn the steam cleaner off and allow it to cool down for at
least 5 minutes.
3. To prevent scalding from escaping steam or hot water while releasing the cap,
place a dry cloth over it.
4. Carefully release the safety cap and unscrew it anti-clockwise.
Warning:
Never release the safety cap by force. If it is not possible to release by regu-
lar, adequate power, wait till the temperature and pressure decrease. Do
not touch the metal parts of the cap. These are very hot, and they may
cause scalding when misused.
5. Pour out the rest of the water from the tank.
6. Insert the funnel in the tank neck and pour clean inside.
7. Screw the safety cap clockwise and tighten firmly.
8. Wipe the hot water drops on the steam cleaner and around it with dry cloth.
9. Insert the plug to the power socket and continue in using.
Using instructions
When cleaning the window panels, pay attention the outside low temperature may
lead to excessive glass tension which can even cause its cracking. Therefore, do not use
the steam cleaner for cleaning windows when the outside temperature is too low.
When cleaning glass, window, or similar fragile surfaces, avoid long cleaning at one
place. It is recommended to use brush nozzle with cloth which distributes the heat
and steam to larger surface.
When cleaning glued, or painted surfaces, try the steam cleaner in smaller place first
not to lose, or remove the paint due to heat and moisture. Clean such surfaces only for
EN - 10