Cleaning The Steam Nozzle - Siguro SGR-ST-D400W Bedienungsanleitung/Übersetzung Der Originalanleitung

EN
Water hardness
I Soft water
II Medium hard water
III Hard water
IV Very hard water
Note:
Ask your supplier for the information about the water hardness.
1. Make sure the steam cleaner is switched off and disconnected from the power
socket.
2. Mix around 10g of citric acid with water, stir well to dissolve the acid. Or you can mix
a solution of white vinegar and water in the ratio 2:3.
3. Unscrew the safety cup and pour water with acid or vinegar solution into the water
tank.
4. Leave on (depending on the water hardness for up to 6 hours) and then pour out
the water.
5. Repeat if needed.
6. Thoroughly rinse with clean and cold water to remove the rest of the limescale.
Safety cap o-ring
If the safety cap o-ring is damaged, it must be replaced for a new one.
Remove the damaged o-ring and attach a new one. Make sure it is safely attached and
it does not obstruct when screwing the cap.
Warning:
Never use the safety cap with a damaged o-ring.
Outer surface and accessories
Wipe the outer surface of the steam cleaner and accessories with a slightly damp, soft
cloth. Wipe dry.
The brush nozzle cloth is washable. You can wash it after each use, or if needed accor-
ding to the instructions on the label. The cloth is not suitable for dryer.

Cleaning the steam nozzle

Regularly clean the steam nozzle to prevent from clogging or blocking.
Storage
Before storing, make sure that the appliance and its accessories are cool and clean.
Store the appliance and its accessories in a dry and well-ventilated place out of the
reach of children or pets.
Do not place any objects on the appliance.
°dH mmol/l
0–7 0 – 1,3
7–14 1,4 – 2,5
14–21 2,6 – 3,8
> 21 > 3,9
EN - 12
Number of fillings
35
30
25
15