Teka DHT 97670 ROS WH Bedienungsanleitung Seite 41

- Entfernen Sie den Schutzkunststoff nicht von der Haube, bis
sie vollständig installiert ist, wenn dieser Kunststoff nicht in
Bereichen vorhanden ist, die während der Installation
beschädigt werden könnten. Dadurch werden Schäden an der
Außenseite des Geräts vermieden, die nicht durch die
Garantie abgedeckt sind.
WARNINGS FOR ELECTRICAL CONNECTION
- Electrical connections shall be approved by a qualified
electrician before using the appliance.
- Electrical connection shall be performed by just one qualified
electrician, who will be responsible for proper electrical
connection of the appliance to power supply.
- Before connecting the appliance to the electrical network,
check if voltage, frequency and power values specified in the
rating label of the appliance are compatible with home power
supply and socket.
- The power cord shall be connected to an omnipolar magneto-
thermal breaker with a switch-contact gap of at least 3 mm.
- In case the power cord is damaged, it shall be replaced either
by the manufacturer or the technical assistance service or by
specialized personnel.
- The power cord shall not enter into contact with surfaces
whose
temperature exceeds 50° C once the appliance has been
installed.
41