Teka DHT 97670 ROS WH Bedienungsanleitung Seite 24

MAINTENANCE
WARNING! Before any cleaning or maintenance operation, remove the hood power supply by
removing the cable or disconnecting the main switch in the home. Cleaning and ordinary
maintenance must not be done by children without supervision.
Cleaning
The product should frequently be cleaned both internally and externally using a cloth
dampened with lukewarm water and neutral non-abrasive liquid detergent.
The metallic grease filters
It has the task of retaining the fat particles from the cooking fumes and preserving the motor of
the aspirator, so it is subject to clogging in variable times in relation to the use of the appliance.
The filters can be washed in the dishwasher with short wash cycles and at low temperatures,
at the latest every 2 months to avoid the risk of fire. After some washes the filter could change
color, due to dishwasher salts and detergents. The color change does not affect the
functionality of the grease filter.
Ceramic filters
They have the task of retaining odors and purifying the air that is returned to the environment.
The ceramic filters can be cleaned in the oven at a temperature of 180/200 ° C for about 45/60
minutes. It is recommendable to replace the ceramic filters every 5 years to assure the best
odor elimination.
Lighting
The hood is equipped with lighting based on high efficiency LED technology, low power
consumption and very high durability under normal conditions of use.
For replacement, contact the service department.
THE COMPANY MANUFACTURER can't be held responsible for any damage caused by
an improper installation or use of this appliance.
PROBLEM
The lights of the cooker
hood do not turn on
TROUBLESHOOTING
POSSIBLE CAUSES
Lamp connector is disconnected
On/off switch is in position 0
No electricity
Remote control is not synchronised
Hook up the lamp connector as shown
on page 5, Fig. 5 of the manual.
Set the on/off switch to position 1 as
shown on page 4, Picture 4 of the
instruction manual.
Check the Lighting Driver.
Synchronise the remote control as
described in the instruction manual
from page 20.
24
SOLUTIONS