Troubleshooting Maintenance And Care; Maintaining The Burner - Parkside PPS 40 A1 Bedienungs- Und Sicherheitshinweise

Consumables
wear quickly?
• Maintenance and care

• Maintaining the burner

The parts displayed in Figure F are the
„
electrode 8d , diffuser
8c . They can be replaced once the
nozzle clamping sleeve
unscrewed.
The electrode 8d
„
if there is a crater of approximately
1.5 mm depth in the centre.
ATTENTION!
fTo unscrew the electrode, do not apply
irregular pressure, gradually increase
pressure until the thread is released.
The new electrode must be screwed into
its bracket and blocked but not tightened
up to the stop.
The nozzle 8c must be placed if the
„
central bore is damaged or if it has
Performance was
„
overstretched.
Arc control time exceeded.
„
Incorrect pistol assembly.
„
Insufficient air supply,
„
pressure too low.
Faulty air compressor.
„
8e and the nozzle
8b has been
must be replaced
Troubleshooting / Maintenance and care
Material too thick, increase
„
the angle to avoid material
from being blown back into
the tip.
Do not control the arc for
„
more than 5 seconds.
You can also start with contact
between the pistol and metal
or with a 3.2 mm distance
to the metal.
See paragraph titled
„
'Pistol set up'.
Check the air filter,
„
increase the air pressure.
Check the performance of the
„
air compressor and make sure
the inlet pressure is at least
100 PSI.
expanded in comparison to a drilling of
a new nozzle. If the electrode
nozzle 8c are replaced too late, this can
result in an overheating of the parts. This
can reduce the lift cycle of the diffuser
Once replaced, make sure the nozzle
clamping sleeve
sufficiently.
ATTENTION!
fThe nozzle clamp sleeve
be screwed on to the burner
it has been equipped with the electrode
8d , diffuser
fIf these parts are missing,
the device may malfunction
and it may create a hazard
for the operating personnel.
8d
8b is tightened
8b must only
8 once
8e and nozzle 8c .
GB/CY
or the
8e .
19