Parkside PAGG 4 A1 Originalbetriebsanleitung Seite 8

Noise emission value
Noise measurement value determined in accordance with
EN 62841 . The A-rated noise level of the power tool is typically
as follows:
Sound pressure level
Uncertainty
Sound power level
Uncertainty
Wear ear muffs!
Total vibration value
Uncertainty
NOTE
► The vibration emission values and the noise emission values
given in these instructions have been measured in accordance
with a standardised test procedure and can be used for
comparison of the power tool with another tool .
► The specified total vibration values and the noise emission
values can also be used to make a provisional load estimate .
WARNING!
► Depending on the manner in which the power tool is being
used, and in particular the kind of workpiece that is being
worked, the vibration and noise emission values can deviate
from the values given in these instructions during actual use of
the power tool .
► Try to keep the load as low as possible . Measures to reduce
the vibration load are, e .g . wearing gloves and limiting the
working time . Wherein all states of operation must be included
(e .g . times when the power tool is switched off and times where
the power tool is switched on but running without load) .
PAGG 4 A1
L = 82 .6 dB (A)
pA
K = 3 dB
pA
L = 93 .6 dB (A)
WA
K = 3 dB
WA
a = 2 .8 m/s
h
K = 1 .5 m/s
2
2
GB │ CY │ 5 ■