Maintenance; Clean And Disinfect; Service And Testing Schedule - INTERSPIRO Inspire Gebrauchsanweisung

Maintenance

Clean and disinfect

Clean, disinfect and dry parts as necessary after use.
Use cleaning and disinfecting solvent recommended by Interspiro.
Face mask and exhalation valve
1. Disconnect the breathing valve from the face mask.
2. Wash the face mask manually in warm cleaning fluid (maximum 55° C).
3. Rinse the parts in clean water.
4. Disinfect the face mask and the exhalation valve assembly. Follow the instructions supplied with
the desinfectant.
5. Rinse the face mask and the exhalation valve assembly thoroughly with clean water.
6. Shake the mask to remove excess water and dry the mask and the exhalation valve assembly.
Breathing valve
1. Mount parking plug, 33438-52, on the breathing valve.
2. For Inspire-FB: Make sure the lever is in the position for activated air to the mask.
3. With breathing hose attached to the breathing valve, pressurize the breathing valve.
4. For Inspire-H & Inspire-A: Press the purge button until a puff of air is heard. Hold onto the washing
plug or press it back into place afterwards.
5. Wash it manually in warm cleaning fluid (maximum 55° C) with a brush or sponge.
6. Rinse the breathing valve in clean water (maximum 55° C).
7. Depressurize and disconnect the breathing valve from the pressure source.
8. Remove the parking/eashing plug 33438-52.
9. Dry the breathing valve.
10. The O-ring of the connection is lubricated if necessary with silicone grease (331900269) to ensure
that the valve can easily be pushed into the quick coupling to the mask.

Service and testing schedule

Service and testing must as a minimum be carried out according to Interspiro's Service and Testing
Schedule, or according to local requirements. Visit www.interspiro.com for latest version.
14
Inspire