ECOVACS AIRBOT Z1 Bedienungsanleitung Seite 6

according to local laws and regulations
before disposal of the Appliance.
25. When not using the Charging Dock or AC Adapter
for a long period of time, please unplug it.
26. The Appliance must be used in accordance
with the directions in this Instruction Manual.
ECOVACS ROBOTICS cannot be held liable
or responsible for any damages or injuries
caused by improper use.
27. The Robot contains batteries that are only
replaceable by skilled persons. To replace
the Robot's battery, please contact Customer
Service.
28. If the Robot will not be used for a long time,
fully charge the Robot and power OFF for
storage, and unplug the Charging Dock and
AC Adapter.
29. WARNING: For the purposes of recharging
the battery, only use CH2110 Charging
Dock, GM95-240375-D Power Adapter unit
provided with this appliance.
30. This appliance contains a UV-C emitter.
Unintended use of the appliance or damage
to the housing may result in the escape of
dangerous UV-C radiation. UV-C radiation
EN
6
may, even in little doses, cause harm to the
eyes and skin. The UV-C emitter cannot be
replaced by user.
To satisfy RF exposure requirements, a separation
distance of 20 cm or more should be maintained
between this device and persons during device
operation.
To ensure compliance, operations at closer than
this distance is not recommended. The antenna
used for this transmitter must not be co-located in
conjunction with any other antenna or transmitter.
Output power of the Wi-Fi module is less than
100mW.
Device Update
Typically, some devices are updated bi-monthly,
but not always so speci c.
Some devices, especially those that went on sale
more than three years ago, will only be updated if
a critical vulnerability is found and xed.
Direct current
Alternating current