Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Verify that the product is connected to mains by means of a suitable,
permanently installed cable (for example, NYM-J 2 x 1.5 mm²).
Verify that the power supply to the product is separately fused
(16 A maximum).
1. Open the product.
2. If you want to route the mains cable or relay cable through the top of
the housing, replace the rubber grommet at the top of the housing by
the enclosed cable gland.
3. Route the mains cable through the upper or bottom cable gland into the
product.
4. Connect the phase to terminal L1 and the neutral conductor to
terminal N.
5. Close any cable glands of the product that are not used by means of
the enclosed plugs.
Eurovac HV
EN
Werbung
