General Power Tool Safety Warnings; Rotary Hammer Safety Warnings - Makita HR2230 Betriebsanleitung

ENGLISH (Original instructions)
1. Switch trigger
2. Lock button
3. Reversing switch lever
4. Action mode changing knob
5. Grip base
6. Side grip
7. Loosen
SPECIFICATIONS
Capacities
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s). The lightest and heaviest combination, according to EPTA-
Procedure 01/2014, are shown in the table.
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone.
It is also suitable for drilling without impact in wood, metal,
ceramic and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
4
Explanation of general view
8. Tighten
9. Teeth
10. Protrusion
11. Bit shank
12. Bit grease
13. Bit
14. Chuck cover
Model
Concrete
Core bit
Diamond core bit (dry type)
Steel
Wood
-1
)
Blows per minute
Overall length
Net weight
Safety class
ROTARY HAMMER SAFETY
ENE042-1
WARNINGS
Safety instructions for all operations
1. Wear ear protectors. Exposure to noise can cause
hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
ENF002-2
Loss of control can cause personal injury.
3. Hold the power tool by insulated gripping
surfaces, when performing an operation where the
cutting accessory may contact hidden wiring or its
own cord. Cutting accessory contacting a "live" wire
may make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
Safety instructions when using long drill bits with
GEA010-2
rotary hammers
1. Always start drilling at low speed and with the bit
tip in contact with the workpiece. At higher speeds,
the bit is likely to bend if allowed to rotate freely
without contacting the workpiece, resulting in personal
injury.
2. Apply pressure only in direct line with the bit and
do not apply excessive pressure. Bits can bend,
causing breakage or loss of control, resulting in
personal injury.
Additional safety warnings
1. Wear a hard hat (safety helmet), safety glasses
and/or face shield. Ordinary eye or sun glasses
are NOT safety glasses. It is also highly
15. Depth gauge
16. Dust cup
17. Blow-out bulb
18. Chuck adapter
19. Keyless drill chuck
20. Sleeve
21. Ring
HR2230
22 mm
54 mm
65 mm
13 mm
32 mm
0 -1,050
0 - 4,050
357 mm
2.6 - 3.1 kg
/II
GEB243-1