Cosatto nitty gritty giggle 2 Bedienungsanleitung Seite 6

Fitting & operation information:
Please refer to the following diagrams:
Chassis
Front wheel
Rear wheel
Brake
Front swivel lock
Basket
Chassis
Carrycot
Carrycot carry
handle
Carrycot hood
Carrycot apron
1- Opening:
Release the autolock (1) and lift the handle upwards until the chassis locks into position
(2).
Check the chassis has locked in place.
2- Adjusting handle position:
3- Fitting:
4- Removing:
5- Fitting:
6- Removing:
7- Applying:
8- Releasing:
9- Applying:
10- Releasing:
11- Removing:
12- Closing:
Note:
upright recline position.
While pressing the primary release button (1), pull both secondary levers (2) back.
Press down on the handle (3) until the autolock retains the chassis in the folded
position (4).
Fold handle inwards 2 to achieve the most compact fold (5).
13- Preparation:
Remove mattress and liner from carrycot (1).
Unfold both frame bars until they locked into positions (2).
14-
Attach the carrycot handle to the carrycot (3).
There are a set of "D" ring located at the base of the carrycot for the attachment of a
separate safety harness approved to BS EN 13210 should this be required (harness not
supplied). Push the "D" rings through the slots in the liner (4).
15- Fitting:
Note:
Dots are marked on the seat mounts and carrycot mounts (1). These should be on the
16- Removing:
Note:
clear of the chassis.
17- Removing:
18- Fitting:
19- Adjusting:
20- Removing:
21- Fitting:
Removing is a reversal of this procedure.