Remote Control; Air Filter - Zibro P 24 Gebrauchsanweisung

A
E B
D B
C
F
d
4
72
2. By pressing the timer but without turning on the other functions, you can
PRE-SET the time for the machine to work. For example, if you press the timer
to '2', the unit will work automatically after 2 hours.
G
nOte!
The compressor has been set so that it starts functioning three minutes
after the (re)start of the air conditioner. The cooling will switch off when
the room temperature is lower than the set temperature. Air circulation
will however continue to work on the set level. When the room
temperature rises above the set temperature, the cooling will work again.
SleeP mOde
By pressing the Sleep button, the set temperature will increase 1ºC at the first
hour, another 1ºC at the second hour. The unit will then keep its temperature.
The ventilation will remain at low speed.
After pressing the sleep button again, the set temperature and ventilation
speed will return to the pre-selected one.
G
nOte!
This function is not available in the Auto or Fan mode.

remOte cOntrOl

a. Power on/off button
b. Temperature +/- buttons
c. Fan Speed button
d. Timer button
e. Function button
f. Sleep button
The remote control works in combination with the control panel. Aim the front end of
the remote control at the control panel. The maximum operating distance from the air
conditioner is approximately 5 metres. Place 2 pieces of AAA Batteries before use.

Air filter

Place the loose filters in the filter holder.
• Take the filter holder out of the air conditioner
• Open the filter holder and place the active carbon filter in the filter holder.
• Place the filter fixing component back in the holder.
• Place the filter holder back in the air conditioner.
The screen filter has to be cleaned once a week with a vacuum cleaner to avoid
blocking of the air flow.
To take out and place back the screen filter, see pictures at the side.
G
nOte!
• Never use the air conditioner without the air filter.