Troubleshooting; Service Data - Electrolux KOCGS30TX Benutzerinformation

Step 1
Turn off the oven. Wait until the
oven is cold.
Back lamp
Step 1 Turn the glass cover to remove it.
Step 2 Clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Install the glass cover.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 What to do if...
In any cases not included in this table please
contact with an Authorised Service Centre.
Problem
The oven does not heat
up.
The door gasket is dam‐
aged.
The display shows
"12.00".
There is water in the
oven cavity.
- indicator is off.

13.2 Service data

If you cannot find a solution to the problem yourself, contact your dealer or an Authorised
Service Centre.
The necessary data for the service centre is on the rating plate. The rating plate is on the front
frame of the oven cavity. Do not remove the rating plate from the oven cavity.
24 ENGLISH
Before you replace the lamp:
Disconnect the oven from the
Check if...
The fuse is blown.
Do not use the oven.
Contact an Authorised
Service Centre.
There was a power cut.
Set the time of day.
There is not too much
water in the tank.
There is enough water in
the water tank. If water
starts to leak in the oven,
and the indicator is still
off contact an Authorised
Service Centre.
Step 2
Put a cloth on the bottom of the cav‐
mains.
Problem
- indicator is on.
The steam cooking does
not work.
The steam cooking does
not work.
It takes more than three
minutes to empty the wa‐
ter tank or the water
leaks from the steam inlet
opening.
The lamp does not work.
Step 3
ity.
Check if...
There is enough water in
the tank. If the tank is full
and the indicator is still
on contact an Authorised
Service Centre.
There is no lime residue
in the steam inlet open‐
ing.
There is water in the wa‐
ter tank.
There is no lime residue
in the steam inlet open‐
ing. Clean the water tank.
The lamp is burnt out.