Klarstein BARETT Bedienungsanleitung Seite 33

Lighting
Press the LIGHT button to switch on the light. Press the button again to switch it off. The
light is independent of other functions.
Increase speed
The motor offers 3 speed levels: low, medium and high.
• Press the SPEED button once to run the motor at low speed.
• Press the SPEED button twice to run the motor at medium speed.
• Press the SPEED button 3 times to run the motor at high speed.
Reduce speed
Each time you press the [-] button, the speed is reduced to the next level. The display
indicates the corresponding speed. If you want to switch off the motor, press the [-]
button until the motor stops.
Setting the timer
1 Press the TIMER button to activate the timer function. The timer is initially set to 5
minutes. Each time you press [+], the time is increased by 1 minute. Each time you
press [-], the time is reduced by 1 minute. A time of 1-60 minutes can be set.
2 Once you have set the timer, press the TIMER button again to confirm or wait 10
seconds until the set time is automatically accepted. The motor runs until the timer
has counted down the time, then it switches off automatically.
3 In case you want to use the set time again the next time, just press the TIMER button
and then wait 10 seconds until the last set time is applied. If you want to enter a
different time, proceed as described in steps 1 and 2. After the timer has been
confirmed, the motor continues to run until the timer has counted down the time.
Note: If you want to end an active timer prematurely, press the TIMER button again
while the timer is running.
EN
33