Klarstein BARETT Bedienungsanleitung Seite 29

7. Attach the 4 wire ropes to the cover and use the locking nut to secure the cover to
the suspension board. (See image 5). Note that the hole for the power cable on
the cover plate should be in the same direction as the hole for the power cable on
the cooker bonnet.
Image 5
Decorative
Cover
8. Follow steps 1 and 2 on image 6 to insert the 4 wire ropes into the slot of the top
plate of the cooker bonnet and use four countersunk screws (ST4*8 mm) to fix the
wire ropes and prevent them from slipping out again (see image 6).
Insert the wire ends (1) and
push them forward into the
slot (2)
Lock nut
Image 6
Countersunk screw
EN
29