Maintenance - Sport-Tec LOJER DOPPELZUGAPPARAT SPEED PULLEY 100 Bedienungsanleitung

Instructions for use
8.4

Maintenance

Change the Pulley rope according to Image 19 below.
Image 19. Rope splicing (Speed Pulley on the left and Pulley on the right)
1. Slide the rope between the two wheels on the upper roller frame.
2. Pull it down and around the lower wheel so that the rope comes out behind
the wheel.
3. Pull the rope all the way up and circle it around the two front right wheels so
that it comes out from behind the wheel.
- Alternatively, the rope can be threaded from front to back on all wheels
creating a cross between the upper and lower wheels.
4. Note that the rope goes behind the last upper wheel and comes out from the
front.
5. Finally, slip the rope through the wheel on the lower roller frame.
Change the Vertical Pull rope:
1. Splice the rope around the upper wheels in the crossbar and pull it down
around the lower wheel in the roller frame.
2. Pull the rope up, circle it around the upper wheel and attach it to the weights
(look at Image 20 a).
3. You can splice the other end of the rope around the lower adjustment wheel,
as the blue triangle sticker of the wheel is on the bottom (look at Image 20 b)
- When changing the rope, make sure that the rope is attached correctly.
- Lock the rope inside the hook case from both ends and splice the rope
crosswise (look at Image 20 c).
Copyright © Lojer Oy, 2021
Lojer Pulleys for Medical Training Therapy / Version 4.0
25