Mounting The Device - Sport-Tec LOJER DOPPELZUGAPPARAT SPEED PULLEY 100 Bedienungsanleitung

Instructions for use
6.2

Mounting the device

When the Pulley, Speed Pulley or Vertical Pull is assembled and ready for use, it
can be mounted to a stable and sturdy wall or to a durable structural steel beam
bar.
Install the device on the ground, with the back of the device against the wall to
your preferred spot. Mark the holes of the mounting irons on the wall with a
marker.
Move the Pulley out of the way and drill the holes according to the markings. Lift
the device up to the wall, focus the device with the holes on the wall and check
that the Pulley is in level with a spirit level. Use appropriate screws or anchors to
attach the device to the wall. Make sure the device is securely mounted, by trying
to move it gently in all directions by hand.
Image 14. Directions of the load caused by using the pulley. 1) Wall, 2) Pulley
Maximum force values described below, come from using the Lojer Pulleys as is
intended. User has to consider these values with the use of the device and make
sure that mounting structure can withstand these forces when mounting a Lojer
Pulley.
Product
Pulley 14 kg
Pulley 20 kg
Speed Pulley 50 kg
Speed Pulley 80 kg
Speed Pulley 100 kg
Table 3.
Copyright © Lojer Oy, 2021
Lojer Pulleys for Medical Training Therapy / Version 4.0
frame, 3) Mounting screw
Max. Traction Force / mounting point
(Direction A in image 14)
190 N
280 N
375 N
600 N
750 N
Maximum force values generated from the intended use of a Lojer
Pulley
Max. Shear Force / mounting point
(Direction B in image 14)
95 N
140 N
188 N
300 N
375 N
15