Quick TCD 2022 Installations- Und Benutzerhandbuch Seite 15

INSTALLATION OF CONTROL
The typical installation procedure is described herein. Needless to say, it is not possible to describe a procedure applicable
for all situations that may be encountered. Adapt this procedure to satisfy your own personal requirements.
Identify the most appropriate position for the control seat on the basis of the following criteria:
• The control panel must be positioned so that it can easily be used and/or seen by the operator.
• Select a clean, smooth and flat area.
• There must be enough space behind the chosen position to house the rear of the control and the wiring.
• The rear part of the control panel must be protected from water and damp.
• Pay careful attention when drilling the panel or parts of the boat. This hole should not weaken or break/crack the boat's
structure.
The TCD control comply with EMC standards (electromagnetic compatibility). In any case correct installation is fundamental
in order not to affect its performance or interfere with operation of instruments found near it.
For this reason the TCD control must be at least:
• 30 cm away from the compass.
• 50 cm away from any radio receivers.
• 1 m away from any radio transmitters (except for SSB).
• 2 m away from any radio transmitters SSB.
• 2 m away from the path of the radar beam.
After determining the position of the control, proceed as follows:
Example of installation with TCD 2022 control
The procedure for TCD 2042 control is the same, as shown in the example.
TCD2022 -TCD2042 THRUSTER CONTROLS REV001A
• Place the drill template on the surface where the instrument will be
Fig. 1
installed and mark the center of the hole.
• Drill the hole for the back of the instrument with a 63 mm bit.
• Remove the template and any burrs present in the hole.
• Clean the surface before application.
• To avoid fitting the control in a crooked position, it is recommended to
insert it into the hole without removing the protective paper from the
gasket. After checking that the dashboard is correctly aligned;
(Fig. 1) draw the control perimeter with a pencil; remove the control;
• (Fig. 2) detach the protective paper from the adhesive gasket taking
care not to touch the adhesive side with your fingers;
• re-insert the control into the hole and position it following the line
drawn in pencil. Press the control to make it adhere well to the surface.
WARNING:
it is recommended not to apply
the adhesive gasket at temperature
18°
below 18° C.
Fig. 2
• (Fig. 3) At the end of installation, remove the transparent protective
film from the control surface. It is recommended to use a piece of
adhesive tape to remove the transparent film.
Fig. 3
INSTALLATION
15
EN