Solvis Fera Montageanleitung Seite 15

1.2 Static Requirements and Dimensions
1.2.1 Edge and Corner Areas
Increased static loads occur at the edge area of the roof.
CAUTION
Observe the minimum edge spacing
• On flat roofs, all superstructures should main-
tain a minimum spacing of 1 m to the edge of
the roof.
h
Fig. 15: Minimum spacing to edge of building
SOLVIS FDS SolvisFera · Technische Änderungen vorbehalten 09.16 · E 63-M
e' ≥ 1m
e ≥ 1m
e'
e
l
1 Flat roof holders Fera Installation Guide EN
1.2.2 Static Design
For additional information on statics, dimensions,
etc., see the
collector.
b
installation instructions for the
15