Zibro P 126 Gebrauchsanweisung Seite 76

a
b
c
c
d
e g
f
4
76
G
NOTE!
The compressor has been set so that it starts functioning three minutes
TO SWITCH OFF THE UNIT AT A CERTAIN TIME
after the (re)start of the air conditioner.
• When the unit is operating in the required mode press the -button. The
The cooling will switch off when the room temperature is lower than
light "Timer set" will flash.
the set one. Air circulation will however continue to work on the set
• Use the and
level. When the room temperature rises above the selected value, the
• When the set time has expired the unit will switch off.
cooling will work again.
REMOTE CONTROL
a. LCD Screen
b. Power on/off button
c. Timer and thermostat setting buttons
d. Mode button (select A/C, Fan or Dehumidifier)
e. A/C Fan Speed button (High, Medium, Low)
f. Timer ON / OFF button
g. Celsius / Fahrenheit selector
The remote control works in combination with the control panel. Aim the front
end of the remote control at the red window. The maximum operating distance
from the air conditioner is approximately 5 metres. Place 2 pieces of AAA Batteries
before use.
TIMER PROGRAMMING
1 Press the button
control panel to
2 Press the or buttons on the remote or the
control panel to set the desired shut-off period.
3 The unit will shut off when the set time elapses.
DEHUMIDIFACATION OPERATION
Press the button on the remote or the MODE button on the control panel to
select the dehumidifier mode. The fan will operate on low speed.
The dehumidifier indicator light will illuminate and stay solid while the unit is
dehumidifying. When the humidity in the room is 50% or lower, the compressor
will not run, the unit will not dehumidify, and the dehumidifier light will blink.
Remember, the exhaust hose does not need to be used in dehumidifier mode.
buttons to set a time between 1 and 12 hours.
on the remote or the "Timer Setting" button on the
turn on the Timer Function.
or buttons on the