Zibro P 126 Gebrauchsanweisung Seite 75

COOLING
When the unit is in the cooling mode, the following functions apply:
• The fan speed can be adjusted by pressing the
Maximum setting.
Medium setting.
Lowest setting.
• The temperature can be set by pressing the
between 16°C en 32°C. The display will show the set temperature for 15
seconds and the "set temp" will light up. Fifteen seconds after setting the
required temperature, the display will show the room temperature.
G
It depends on the environment whether the required temperature will
be reached. It is not a malfunction of the air conditioner if the room
temperature remains above the "set temp".
DEHUMIDIFYING
When the unit is primarily used as a dehumidifier, then please follow these
instructions: Do not connect the air exhaust hose and let the warm air go
back into the room. Connect a drainage hose onto the permanent drain
connector on the back of the unit (refer to Chapter G). You must connect a
drain tube to the water outlet 8 (refer to Chapter G).
When the unit is in the dehumidifying mode, the fan speed cannot be
adjusted when the temperature is below 25ºC. The fan speed will be
automatically set on 'Medium setting'. Adjusting of the temperature setting
does not have any effect when in dehumidifying mode.
AIR CIRCULATION
In this mode the unit only circulates air; the unit will not cool or dehumidify.
The air entering the unit is not cooled or dehumidified, but is filtered.
When the unit is in this mode, the following functions apply:
• The fan speed can be adjusted by pressing the -button
Maximum setting.
Medium setting.
Lowest setting.
4 When the unit is switched off the most recent setting will be stored in
memory.
5 The timer function allows you to switch the unit on or off at a certain time.
TO SWITCH ON THE UNIT AT A CERTAIN TIME
• Ensure that the unit is set in the required operating mode
• Switch off the unit by pressing the
properly inserted into the wall outlet.
• Press the -button. The light "Timer set" will flash.
• Use the and
• When the set time has expired the unit will switch on.
-button. Ensure that the plug is
buttons to set a time between 1 and 24 hours.
-button
and buttons, anywhere
, of
4
75
.