Specifications - Makita GS6000 Betriebsanleitung

ENGLISH (Original instructions)
1. Switch trigger
2. Lock lever
3. Hex wrench
4. Hex bolt
5. Hex lock nut
6. Tighten
7. Loosen
8. Wing bolt
9. Support cover
10. Lock nut
11. Grinding wheel

SPECIFICATIONS

Maximum wheel capacity (diameter  thickness)
No load speed (min
Overall length
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
...... Read instruction manual.
................ DOUBLE INSULATION
...... Wear safety glasses.
................ Only for EU countries
Do not dispose of electric equipment
together with household waste
material!
In observance of European Directive
2012/19/EU on waste electric and
electronic equipment and its
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible
recycling facility.
Intended use
The tool is intended for grinding ferrous materials or
deburring castings.
Explanation of general view
12. Spindle
13. Screwdriver
14. Inner flange
15. Lock nut wrench
16. Hex nut
17. Outer flange (convex type)
18. Outer flange (flat type)
19. Exhaust vent
20. Inhalation vent
21. Handle R
22. Dust cover attachment R
Model
Spindle thread
-1
)
With support cover
Without support cover
With support cover
Without support cover
Safety class
125 mm  20 mm
END202-7
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
STRAIGHT GRINDER SAFETY
WARNINGS
Safety Warnings Common for Grinding Operation:
1. This power tool is intended to function as a
grinder. Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed
ENE050-1
below may result in electric shock, fire and/or serious
injury.
23. Handle L
24. Dust cover attachment L
25. Hook B
26. Hook A
27. Rib A
28. Vent A
29. Vent B
30. Commutator
31. Insulating tip
32. Carbon brush
33. Brush holder cap
GS5000
M14 or 1/2" (country specific)
5,600
590 mm
588 mm
5.0 kg
4.9 kg
/II
GS6000
150 mm  20 mm
590 mm
588 mm
5.2 kg
5.0 kg
ENF002-2
GEA010-1
GEB108-3
5