Specifications - Makita M9002 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Shaft lock
2-1. Lock button
2-2. Switch trigger
4-1. Wheel guard
4-2. Screw
4-3. Bearing box

SPECIFICATIONS

Depressed center wheel diameter
Max. wheel thickness
Rated speed (n) / No load speed (n
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding of metal and stone
materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause
voltage fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.44 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected
with a fuse or protective circuit breaker having slow
tripping characteristics.
Noise
The typical A-weighted
according to EN60745:
Model M9002
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Explanation of general view
5-1. Lock nut
5-2. Depressed center grinding wheel /
Multi-disc
5-3. Inner flange
6-1. Lock nut wrench
6-2. Shaft lock
Model
Spindle thread
)
0
Overall length
Net weight
Safety class
noise level determined
) : 91 dB (A)
pA
) : 102 dB (A)
WA
M9002
125 mm
11,000 min
361 mm
2.8 kg
ENE077-2
Model M9003
Sound pressure level (L
Sound power level (L
ENF002-2
Uncertainty (K) : 3 dB (A)
Vibration
The vibration
ENF100-1
determined according to EN60745:
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENG905-1
The declared vibration emission value is used for
•
main applications of the power tool. However if the
power tool is used for other applications, the
vibration emission value may be different.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
3
8-1. Exhaust vent
8-2. Inhalation vent
9-1. Limit mark
10-1. Brush holder cap
10-2. Screwdriver
6 mm
M14 or 5/8" (country specific)
-1
10,000 min
/II
) : 90 dB (A)
pA
) : 101 dB (A)
WA
Wear ear protection
total value (tri-axial
) : 9.0 m/s
h,AG
2
M9003
150 mm
-1
361 mm
2.8 kg
ENG900-1
vector sum)
2
ENG902-1