Specifications - Makita SA7000C Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Shaft lock
2-1. Lock button
2-2. Switch trigger
3-1. Speed adjusting dial
6-1. Lock nut
6-2. Abrasive disc

SPECIFICATIONS

No load speed (n
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for the sanding of large surface of
wood, plastic and metal materials as well as painted
surfaces.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode: disc sanding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
Explanation of general view
6-3. Rubber pad
7-1. Lock nut wrench
7-2. Shaft lock
9-1. Exhaust vent
9-2. Inhalation vent
10-1. Commutator
Model
Disc diameter
Spindle thread
) / Rated speed (n)
0
Overall length
Net weight
Safety class
) : 88 dB (A)
pA
) : 99 dB (A)
WA
value (tri-axial vector
2
) : 2.5 m/s or less
h,DS
2
ENE052-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
The declared vibration emission value is used for
•
main applications of the power tool. However if the
power tool is used for other applications, the
ENF002-2
vibration emission value may be different.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
ENG905-1
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
ENG900-1
We Makita
manufacturer declare that the following Makita
sum)
machine(s):
Designation of Machine:
Angle Sander
Model No./ Type: SA7000C
are of series production and
ENG902-1
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following
standards or standardised documents:
EN60745
3
10-2. Insulating tip
10-3. Carbon brush
11-1. Brush holder cap
11-2. Screwdriver
SA7000C
180 mm
M14
-1
4,000 (min )
453 mm
3.4 kg
/II
Corporation as the
ENH101-16
responsible