Connection To The Electricity Grid; Use - Employment - COMAC cacube 20 Bedienungs- Und Wartungsanleitung

DANGER:
• To reduce the risk of fire, electric shocks or injury, please read and follow the safety instructions
and warning indications before using. This vacuum cleaner has been designed to be safe when it
is used for cleaning in the specified manner. If damage to electrical or mechanical components is
found, the vacuum cleaner and/or the accessory must be repaired at the relative authorised service
centre or else at the manufacturer before use, in order to prevent further damage to the appliance
or physical injury to the user.
• Before connecting the appliance to the electricity socket, make sure the electrical information on
the plate corresponds to that of the mains supply. The appliance must only be powered with
alternating current and voltage equal to that shown on the serial number plate.
• The power supply cable outlet must have an earth connection in compliance with the regulatory
standards.
• Before using, check for any damage on the connection cable and on the power plug. If the cable is
damaged, immediately contact a specialist technician for restoring normal operations.
• Connect the appliance only to an electrical connection installed by an electrical installer in conformity
with IEC 60364-1.
• Never touch the power plug with wet hands.
• Make sure that the cable to the mains or the extension cable have not been damaged by having
been walked on, crushed, pulled or the like. Protect the cable from heat and from contact with oils
or sharp edges.
• Regularly check that the cable connecting to the mains is not damaged, for example with signs of
ageing or cracks. If there is damage, the cable must be replaced by a specialist COMAC technician
or else by a technician with similar qualifications before using the appliance again.
• Protection against splashes of water and the mechanical strength need to be ensured also after
any replacement of the joints of the power cable or the extension cable.
• Do not clean the appliance with a hose or a jet of high pressure water (risk of short-circuit or other
electrical faults).
ATTENTION:
• The procedure causes short-term reduction in voltage.
• In unfavourable grid conditions the other appliances could be damaged.
• This damage could occur if the grid impedance is less than 0.15Ω.
DANGER:
• Never use with a damaged cable or plug. When removing from an electrical socket, pull the plug
and not the cable. Do not handle the plug or the vacuum cleaner with wet hands. Deactivate all the
controls before connecting or disconnecting from the electrical socket.
• Do not pull or transport the appliance by the cable, do not use the cable as a handle, do not close
a door on the cable, and do not pull the cable around edges or sharp corners. Do not pass the
vacuum cleaner over the cable. Keep the cable away from hot surfaces.

CONNECTION TO THE ELECTRICITY GRID

USE - EMPLOYMENT

13