Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
I
NOTE
• The wattage can vary.
• If the boost mode is used, more watt-
age is consumed (see chapter "Techni-
cal data" on page 16).
Timer
The timer can be used to turn off the cooking zone
automatically after the set time has elapsed. The
timer can be set from 0 to 99 minutes.
Over-temperature protection
A temperature sensor monitors the temperature
inside the cooktop. The cooktop turns off if the
temperature sensor detects a too high tempera-
ture.
Unsuitable object protection
If cookware of an unsuitable size, a non-magnetic
object or a small object is left on the cooktop, the
cooktop automatically switches to standby mode
after 1 minute. The cooktop fan then cools the
cooktop for 1 minute.
Automatic shut down timer
The automatic shutdown timer is a safety protec-
tion function. The function shuts down the cooktop
automatically after a certain period of time. The
automatic shutdown times for various power levels
are shown in the below table:
1
Power level
8
Shut down (h)
Cooktop structure (fig. 1, page 3)
No
Description
1
Control panel
2
Ventilation
3
Cooking zone
4
Glass plate
5
Power cable
10
2
3
4
5
6
7
8
8
4
4
4
2
Control panel (fig. 2, page 3)
A beep sounds when the touch buttons are
pressed.
No
Description
1
ON/OFF button
2
Power level indicator
3
Heat level buttons
4
Time indicator
5
BOOST button
6
Timer symbol
7
Lock button
8
Cooking zone selection buttons
Installation
!
WARNING! Electrocution hazard
• Ensure the voltage corresponds to the
value given in the rating plate.
• Ensure the power supply cable sec-
tions can withstand the load specified
on the rating plate.
• Note the specifications in chapter
"Technical data" on page 16.
• The power supply cable must not
touch any hot parts and must be
routed so that its temperature does not
8
9
exceed 75 °C.
2
2
!
WARNING! Fire hazard
• The safety distance between the cook-
top and the device above the cooktop
must be at least 760 mm (fig. 3,
page 3).
• Ensure the cooktop is well ventilated
and the air inlet and outlet are not
blocked (fig. 3, page 3).
!
WARNING! Damage hazard
Use a work surface made of heat-resistant
material.
EN
Werbung
Inhaltsverzeichnis
Fehlerbehebung
