Silvercrest SMZT 500 A1 Bedienungsanleitung Seite 11

Ice cubes
5) Close the bowl 8 with the connecting piece 4:
–
Place it onto the bowl 8 so that the tabs on the outer rim of the connecting
piece 4 grip into the catches on the bowl 8 (see figure 1) .
–
Then, turn the connecting piece 4 so that the tabs slide down into the
catches and engage .
Fig . 1
6) Place the motor unit 1 onto the connecting piece 4 . Make sure that the tabs
on the inner edge of the connecting piece 4 grip into the recesses on the
motor unit 1 and that the motor unit 1 sits firmly in place .
7) Depending on the type of food you want to chop, press speed button I 2 or
speed button II 3 .
NOTES
► If larger pieces of food start collecting on the wall of the bowl during
processing, lift the motor unit 1 off the connecting piece 4 . Give the
bowl 8 a firm shake and restart the processing . Any residues can be
removed with a spatula .
► Particularly hard foods should be cut into small pieces (approx . 2 cm)
before processing . Otherwise, the motor unit could block .
Use a 'pulsing' processing method when working with hard foods . To do
this, press the relevant speed button 2/3 several times briefly in
succession .
► If the food is not completely chopped, you can either cut it into smaller
pieces or lift the motor unit 1 off the connecting piece 4 . Give the
bowl 8 a firm shake and restart the processing .
■ 8 │ GB │ IE │ NI
Food Fill level
Meat 200 g
100 g
Processing time
6 x 5 sec .
15 x 1 sec .
pulse
SMZT 500 A1
Speed
II
II