8.3.2 Setting the display mode
The data shown on the display when this is in standby mode can be set.
a) Use the arrow buttons
b) Use the
button to select the password "7" and then press
c) Use the
button to scroll to and select submenu
d) Set one of the following values using the
"OFF" •
The display remains on the last operation set by the user;
"1"
•
All operating parameters are displayed cyclically;
"2"
The room or water probe temperature is shown, based on the type of configuration
•
"3"
•
The current time is shown
The operating autonomy in hours before having to refill the hopper is shown, If the function
•
"4"
to confirm the settings.
e) Press
8.3.3 Setting the display brightnes
Display brightness when in standby mode can be set.
a) Use the arrow buttons
b) Use the
button to select the password "7" and then press
c) Use the
button to scroll to and select submenu
d) Set the desired brightness (
8.3.4 Setting the volume
The volume of the buzzer can be set based on requirements:
a) Use the arrow buttons
b) Use the
button to select the password "7" and then press
c) Use the
button to scroll to and select submenu [
d) Set the desired volume (OFF, 1 to 5) using the
8.3.5 Setting the type of pellets
The type of pellets used can be set:
a) Use the arrow buttons
b) Use the
button to select the password "7" and then press
c) Use the
button to scroll to and select submenu
d) Set one of the following values using the
"1"
•
Standard pellet (En Plus)
"2"
•
Long pellet
"3"
•
Small pellet
to confirm the settings.
e) Press
to go to the setup menu
"filling" has been activated.
to go to the setup menu
OFF, 1 ... 5
) using the
to go to the setup menu
to go to the setup menu
004772533 - 16/03/2021
and then press
to confirm;
to confirm;
[12]
and press
and
buttons:
and then press
to confirm;
to confirm;
[11]
and press
buttons and press
and then press
to confirm;
to confirm;
13
] and press
buttons and press
and then press
to confirm;
to confirm;
[14]
and press
and
buttons:
;
;
to confirm.
;
to confirm.
;
51